Checking bulbs
With all doors closed, apply the parking brake and push the ignition switch to the ON position without starting the engine. The following lights will come on (if so equipped):
The following lights come on briefly and then go off (if so equipped):
If any light does not come on, it may indicate a burned-out bulb or an open circuit in the electrical system. Have the system checked by a NISSAN dealer.
Some indicators and warnings are also displayed on the dot matrix crystal display on the speedometer. (See “Dot matrix
See also:
Maximum load limits
Maximum trailer loads
Never allow the total trailer load to exceed the
value specified in the “Towing Load/Specification”
chart. The total trailer load equals trailer
weight plus its cargo wei ...
BSW driving situations
Another vehicle approaching from behind
The Blind Spot Indicator light illuminates if a
vehicle enters the detection zone from behind in
an adjacent lane.
However, if the overtaking vehicle is ...
Off-road recovery
If the right side or left side wheels unintentionally
leave the road surface, maintain control of the
vehicle by following the procedure below.
Please note that this procedure is only a general
...