Reprogramming a single HomeLink® button
To reprogram a HomeLink® Universal Transceiver button, complete the following.
1. Press and hold the desired HomeLink®
button. DO NOT release the button.
2. The indicator light will begin to flash after 20
seconds. Without releasing the HomeLink®
button, proceed with “Programming
HomeLink®” - Step 1.
For questions or comments, contact HomeLink® at: www.homelink.com or 1-800-355-3515.
The HomeLink® Universal Transceiver button has now been reprogrammed. The new device can be activated by pushing the HomeLink® button that was just programmed. This procedure will not affect any other programmed HomeLink® buttons.
See also:
To turn the system ON/OFF
Push the “OFF” or “ON·OFF” button when the
heater and air conditioner is off. The system will
turn on with the settings that were used
immediately before the system was turned off. ...
Trunk lid (CrossCabriolet models)
WARNING
• Do not drive with the trunk lid
open.
This could allow dangerous exhaust
gases to be drawn into the vehicle.
See “Exhaust gas (carbon monoxide)”
in the “5. Starting and dr ...
Cargo cover (if so equipped for Hardtop models)
The cargo cover keeps the contents in the cargo
area hidden from the outside.
To use the cargo cover, pull it out and hang both
sides on the hooks1 .
To use the sub cover, hang the straps on ...