Memory storage

Two positions for the driver’s seat, steering

Two positions for the driver’s seat, steering column (if so equipped) and outside mirrors can be stored in the automatic drive positioner memory. Follow these procedures to use the memory system.

1. Move the shift lever to the P (Park) position.
2. Push the ignition switch to the ON position.
3. Adjust the driver’s seat, steering column (if so equipped) and outside mirrors to the desired positions by manually operating each adjusting switch. For additional information, see “Seats” in the “1. Safety — Seats, seat belts and supplemental restraint system” section and “Tilt/telescopic steering” earlier in this section and “Outside mirrors” earlier in this section.
4. Push the SET switch and, within 5 seconds, push the memory switch (1 or 2).

The indicator light for the pushed memory switch will stay on for approximately 5 seconds after pushing the switch.

If memory is stored in the same memory switch, the previous memory will be deleted.

Linking Intelligent Key to a stored memory position

The Intelligent Key can be linked to a stored memory position with the following procedure.

1. Follow one of the steps for storing a memory position.

While the indicator light for the memory switch being set is illuminated for 5 seconds, push theKey. button on the Intelligent Key.
Push the ignition switch to the OFF position, and then push the SET switch. Push the button while pushing the memory button button while pushing the memory button while the indicator light stays on for approximately 5 seconds.

Push the ignition switch to the OFF position, and then push the Intelligent Key. button on the Intelligent Key.

The driver’s seat, steering wheel (if so equipped) and outside mirrors will move to the memorized position.

Confirming memory storage

Push the ignition switch to the ON position and push the SET switch. If the main memory has not been stored, the indicator light will come on for approximately 0.5 second. When the memory has stored in position, the indicator light will stay on for approximately 5 seconds.
If the battery cable is disconnected, or if the fuse opens, the memory will be canceled. In this case, reset the desired position using the previous procedure.
If optional keys are added to your vehicle, the memory storage procedure to switch 1 or 2 and linking Intelligent Key procedure to a stored memory position should be performed again for each Intelligent Key. For additional Intelligent Key information, see “Keys” earlier in this section.

Selecting the memorized position

1. Move the shift lever to the P (Park) position.
2. Use one of the following methods to move the driver’s seat, the outside mirrors and the steering wheel (if so equipped) .

Push the ignition switch to the ON position and push the memory switch (1 or 2).
Within 45 seconds of opening the driver’s door, push the memory switch (1 or 2).

The driver’s seat, steering column (if so equipped) and outside mirrors will move to the memorized position with the indicator light flashing, and then the light will stay on for approximately 5 seconds.

    See also:

    FM/AM/SAT radio with compact disc (CD) player (if so equipped)
    For all operation precautions, see Audio operation precautions in this section. Audio main operation VOL/ON·OFF control: Place the ignition switch in the ACC or ON position and push the VOL/ON· ...

    Seat belt extenders
    If, because of body size or driving position, it is not possible to properly fit the lap-shoulder belt and fasten it, an extender that is compatible with the installed seat belts is available that ...

    Starting the engine
    1. Apply the parking brake. 2. Move the shift lever to the P (Park) or N (Neutral) position. (P is recommended.) The starter is designed not to operate unless the shift lever is in either of the a ...