Windshield wiper and washer switch

In freezing temperatures the washer solution may freeze on the windshield

In freezing temperatures the washer solution may freeze on the windshield and obscure your vision which may lead to an accident. Warm windshield with the defroster before you wash the windshield.

- Do not operate the washer continuously for more than 30 seconds.

- Do not operate the washer continuously for more than 30 seconds.

- Do not operate the washer if the reservoir tank is empty.

- Do not fill the window washer reservoir tank with washer fluid concentrates at full strength. Some methyl alcohol based washer fluid concentrates may permanently stain the grille if spilled while filling the window washer reservoir tank.

- Pre-mix washer fluid concentrates with water to the manufacturer’s recommended levels before pouring the fluid into the window washer reservoir tank. Do not use the window washer reservoir tank to mix the washer fluid concentrate and water.

If the windshield wiper operation is interrupted by snow or ice, the wiper may stop moving to protect its motor. If this occurs, turn the wiper switch to the OFF position and remove the snow or ice that is on and around the wiper arms. In approximately 1 minute, turn the switch on again to operate the wiper.

The windshield wiper and washer operates when the ignition switch is in the ON

The windshield wiper and washer operates when the ignition switch is in the ON position.

Push the lever down to operate the wiper at the following speed:
1 Intermittent — intermittent operation can be adjusted by turning the knob toward A (Slower) or B (Faster).

2 Low — continuous low speed operation
3 High — continuous high speed operation
Push the lever up 4 to have one sweep operation of the wiper.

Pull the lever toward you 5 to operate the washer. Then the wiper will also operate several times.

    See also:

    Engine block heater (if so equipped)
    Engine block heaters are used to assist with cold temperature starting. The engine block heater should be used when the outside temperature is 208F (−78C) or lower. To use the engine blo ...

    Before starting the engine
    • Make sure the area around the vehicle is clear. • Check fluid levels such as engine oil, coolant, brake fluid and window washer fluid as frequently as possible, or at least whenever you ...

    NISSAN Intelligent Key Operation
    Basic information The Intelligent Key system allows you to lock or unlock the doors without removing the Intelligent Key from your pocket, handbag, or another convenient carrying locati ...