Power steering

WARNING

If the engine is not running or is turned off while driving, the power assist for the steering will not work. Steering will be harder to operate.

The power assisted steering uses a hydraulic pump, driven by the engine, to assist steering.

If the engine stops or the drive belt breaks, you will still have control of the vehicle. However, much greater steering effort is needed, especially in sharp turns and at low speeds.

    See also:

    Antenna
    The antenna cannot be shortened, but can be removed. When you need to remove the antenna, turn the antenna rod counterclockwise B . To install the antenna rod, turn the antenna rod clockwise A ...

    Vehicle Dynamic Control (VDC) off switch
    The vehicle should be driven with the Vehicle Dynamic Control (VDC) system on for most driving conditions. If the vehicle is stuck in mud or snow, the VDC system reduces the engine output to r ...

    Panoramic sunshade (if so equipped)
    The panoramic sunshade operates when the ignition switch is in the ON position. The sunshade switch is located near the roof console. When opening or closing the sunshade the switch need not be ...