Interior lights

Do not use for extended periods of time with the engine stopped. This could

Do not use for extended periods of time with the engine stopped. This could result in a discharged battery.

Map lights

Map lights
Map lights

Push the light lens to turn the map light on or off.

The map light control switch has three positions:
ON 1 , DOOR 2 and OFF 3 .

The light 4 (if so equipped) will illuminate when the headlight switch is turned to the position. or ON position position.

ON position

When the switch is in the ON position 1 , the map lights will illuminate.

DOOR position

When the switch is in the DOOR position 2 the map lights will illuminate under the following conditions:
- ignition switch is turned to the LOCK position
— remain on for about 15 seconds.
- doors are unlocked by pushing the unlock button or the request switch (Intelligent Key system equipped model), with the ignition (on the keyfob or Intelligent Key) or the request switch (Intelligent Key system equipped model), with the ignition switch in the LOCK position
— remain on for about 15 seconds.
- any door is opened and then closed with the ignition switch in the LOCK position
— remain on for about 15 seconds.
- any door is opened with the ignition switch in the ACC or ON position
— remain on while the door is opened.
When the door is closed, the lights go off.

The lights will turn off after 30 minutes when the lights remain illuminated to prevent the battery from becoming discharged.

OFF position

When the switch is in the OFF position 3 , the map lights will not illuminate, regardless of the condition.

Ceiling light

Ceiling light
Ceiling light

The ceiling light switch has three positions: ON, DOOR and OFF.

ON position

When the switch is in the ON position 1 , the ceiling light will illuminate.

DOOR position

When the switch is in the DOOR position 2 , the ceiling light will illuminate under the following conditions:
- ignition switch is turned to the LOCK position
— remain on for about 15 seconds.
- doors are unlocked by pushing the unlock button the request switch (Intelligent Key system equipped model), with the ignition switch(on the keyfob or Intelligent Key) or the request switch (Intelligent Key system equipped model), with the ignition switch in the LOCK position
— remain on for about 15 seconds.
- any door is opened and then closed with the ignition switch in the LOCK position
— remain on for about 15 seconds.
- any door is opened with the ignition switch in the ACC or ON position
— remain on while the door is opened.
When the door is closed, the lights go off.

The light will turn off after 30 minutes when the lights remain illuminated to prevent the battery from becoming discharged.

OFF position

When the switch is in the OFF position 3 , the ceiling light will not illuminate, regardless of the condition.

    See also:

    Tire labeling
    Example Federal law requires tire manufacturers to place standardized information on the sidewall of all tires. This information identifies and describes the fundamental characteristics of the ...

    HomeLink® Universal Transceiver (if so equipped)
    HomeLink® Universal Transceiver provides a convenient way to consolidate the functions of up to three individual hand-held transmitters into one built-in device. HomeLink® Universal Transceiver: ...

    Vehicle Dynamic Control (VDC) system
    The Vehicle Dynamic Control (VDC) system uses various sensors to monitor driver inputs and vehicle motion. Under certain driving conditions, the VDC system helps to perform the following functions ...