Seat belt maintenance

● To clean the seat belt webbing, apply a mild soap solution or any solution recommended for cleaning upholstery or carpet.

Then wipe with a cloth and allow the seat belts to dry in the shade. Do not allow the seat belts to retract until they are completely dry.
● If dirt builds up in the shoulder belt guide of the seat belt anchors, the seat belts may retract slowly. Wipe the shoulder belt guide with a clean, dry cloth.
● Periodically check to see that the seat belt and the metal components, such as buckles, tongues, retractors, flexible wires and anchors, work properly. If loose parts, deterioration, cuts or other damage on the webbing is found, the entire seat belt assembly should be replaced.

    See also:

    Important information about this manual
    You will see various symbols in this manual. They are used in the following ways: This is used to indicate the presence of a hazard that could cause death or serious personal injury. To avoid or ...

    Draining of coolant water
    If the vehicle is to be left outside without antifreeze, drain the cooling system, including the engine block. Refill before operating the vehicle. For details, see “Engine cooling system” in ...

    Emergency engine shut off
    To shut off the engine in an emergency situation while driving, perform the following procedure: – Rapidly push the push-button ignition switch 3 consecutive times in less than 1.5 seconds, or ...