Reprogramming a single HomeLink® button
To reprogram a HomeLink® Universal Transceiver button, complete the following.
1. Press and hold the desired HomeLink® button.
Do not release the button until step 4
has been completed.
2. When the indicator light begins to flash
slowly (after 20 seconds), position the
hand-held transmitter 1 - 3 inches (26 -
76 mm) away from the HomeLink® surface.
3. Press and hold the hand-held transmitter
button.
4. The HomeLink® indicator light will flash, first
slowly and then rapidly. When the indicator
light begins to flash rapidly, release both
buttons.
The HomeLink® Universal Transceiver button has now been reprogrammed. The new device can be activated by pushing the HomeLink® button that was just programmed. This procedure will not affect any other programmed HomeLink® buttons.
See also:
Control panel buttons — color screen with navigation system (if so equipped)
Control panel buttons — color screen with navigation system (if so equipped)
1. (brightness control) button
2. Display screen
3. MAP button*
4. NAV button*
5. TRAF button*
6. SETUP button
...
Conditions the remote start will not work
The remote start will not operate if any of the
following conditions are present:
● The ignition switch is placed in the ON position.
● The hood is not securely closed.
● The haz ...
Changing engine coolant
A NISSAN dealer can change the engine coolant.
The service procedure can be found in the
NISSAN Service Manual.
Improper servicing can result in reduced
heater performance and engine overheating ...