Reprogramming a single HomeLink® button
To reprogram a HomeLink® Universal Transceiver button, complete the following:
1. Press and hold the desired HomeLink® button.
DO NOT release the button.
2. The indicator light will begin to flash after
20 seconds. Without releasing the
HomeLink® button, proceed with “Programming
HomeLink®” - Step 1.
For questions or comments, contact HomeLink® at: www.homelink.com or 1–800–355–3515.
The HomeLink® Universal Transceiver button has now been reprogrammed. The new device can be activated by pushing the HomeLink® button that was just programmed. This procedure will not affect any other programmed HomeLink® buttons.
See also:
Engine block heater (if so equipped)
Engine block heaters are used to assist with cold
temperature starting.
The engine block heater should be used when
the outside temperature is 20°F (-7°C) or lower.
WARNING
● Do not use ...
Seat belts
...
To protect your vehicle from corrosion
• Wash and wax your vehicle often to keep
the
vehicle clean.
• Always check for minor damage to the paint
and repair it as soon as possible.
• Keep drain holes at the bottom of the
doors ...