Extending engine run time
The remote start feature can be extended one time by performing the steps listed in “Remote starting the vehicle” in this section. Run time will be calculated as follows:
● The first 10 minute run time will start when
the remote start function is performed.
● The second 10 minutes will start immediately
when the remote start function is performed.
For example, if the engine has been running for 5 minutes, and 10 minutes are added, the engine will run for a total of 15 minutes.
A maximum of two remote starts, or a single start with an extension, are allowed between ignition cycles.
The ignition switch must be cycled to the ON position and then back to the OFF position before the remote start procedure can be used again.
See also:
Parking brake
- Be sure the parking brake is fully released before driving. Failure to do
so can cause brake failure and lead to an accident.
- Do not release the parking brake from outside the vehicle.
- Do ...
Difference between predicted and
actual distances
Basic Information
The guide lines shown on the display and their apparent positions on the ground are intended only as approximate
references. Slopes, uneven surfaces, and objects that extend abo ...
Operating range
The Intelligent Key functions can only be used
when the Intelligent Key is within the specified
operating range from the request switch 1 .
When the Intelligent Key battery is discharged or
st ...