Automatic door locks

• All doors will be locked automatically when the vehicle speed reaches 15 MPH (24 km/h).
• All doors will be unlocked automatically when the ignition switch is placed in the OFF position.

The automatic unlock function can be deactivated or activated. To deactivate or activate the automatic door unlock system, perform the following procedure:

1. Close all doors.
2. Place the ignition switch in the ON position.
3. Within 20 seconds of performing Step 2, push and hold the power door lock switch to the 5 position (UNLOCK) for more than 5 seconds.
4. When activated, the hazard indicator will flash twice. When deactivated, the hazard indicator will flash once.
5. The ignition switch must be placed in the OFF and ON position again between each setting change.

When the automatic door unlock system is deactivated, the doors do not unlock when the ignition switch is placed in the OFF position. To unlock the door manually, use the inside lock knob or the power door lock switch (driver’s or front passenger’s side).

    See also:

    BSW/LDW temporary disabled status
    When the lift gate is open and/or the low washer fluid is detected, the BSW and/or LDW system is turned off temporarily. The BSW light (green) and/or the LDW light (green) will blink, and either o ...

    Variable voltage control system (if so equipped)
    CAUTION • Do not ground accessories directly to the battery terminal. Doing so will bypass the variable voltage control system and the vehicle battery may not charge completely. • Use electr ...

    Basic Information. I-LI system operation. How to enable/disable the I-LI system
    Basic Information WARNING Failure to follow the warnings and operating instructions for the Intelligent Lane Intervention system could result in loss of vehicle control, serious injury, or de ...