Hood

1. Pull the hood lock release handle 1

1. Pull the hood lock release handle 1 located below the instrument panel; the hood will then spring up slightly.
2. Pull the lever2 up at the front of the hood with your fingertips and raise the hood.
3. When closing the hood, slowly close the hood down and make sure it locks into place.

WARNING

• Make sure the hood is completely closed and latched before driving.

Failure to do so could cause the hood to fly open and result in an accident.
• If you see steam or smoke coming from the engine compartment, to avoid injury do not open the hood.

    See also:

    HomeLink® universal transceiver (Type A) (if so equipped)
    The Type A system does not have an IV 1 on the back of the mirror. Move the mirror to see if the IV is present. If the IV is not on the mirror, use the procedure in this section to program the H ...

    Clearing the programmed information
    The following procedure clears the programmed information from both buttons. Individual buttons cannot be cleared. However, individual buttons can be reprogrammed, see “Reprogramming a single Ho ...

    Memory storage function
    Two positions for the driver’s seat, steering column, and outside mirrors can be stored in the automatic drive positioner memory. Follow these procedures to use the memory system. 1. Set the C ...