Closing the top

1. Start the engine.

1. Start the engine.
2. Push CLOSE on the soft top operating switch and hold it until the top is fully closed.

• The soft top indicator light will illuminate while the top is in motion. (In about 20 seconds, the closing movement will finish.)
• Windows will automatically be fully opened.

3. Release the switch when the top is fully closed. (The indicator light will turn off.)

    See also:

    BSW/LDW temporary disabled status
    When the lift gate is open and/or the low washer fluid is detected, the BSW and/or LDW system is turned off temporarily. The BSW light (green) and/or the LDW light (green) will blink, and either o ...

    Tire labeling
    Example Federal law requires tire manufacturers to place standardized information on the sidewall of all tires. This information identifies and describes the fundamental characteristics of the ...

    Jump starting
    To start your engine with a booster battery, the instructions and precautions below must be followed. - If done incorrectly, jump starting can lead to a battery explosion, resulting in severe i ...