Clearing the programmed information
The following procedure clears the programmed information from both buttons. Individual buttons cannot be cleared. However, individual buttons can be reprogrammed, see “Reprogramming a single HomeLink® button” in this section.
To clear all programming:
1. Press and hold the two outer HomeLink®
buttons until the indicator light begins to
flash in approximately 10 seconds. Do not
hold for longer than 20 seconds.
2. Release both buttons.
HomeLink® is now in the programming mode and can be programmed at any time beginning with “Programming HomeLink®” - Step 1.
See also:
Around View® Monitor (if so equipped)
With the ignition switch in the ON position, press
the CAMERA button or move the shift selector to
the R (Reverse) position to operate the Around
View Monitor. The monitor displays various views
o ...
Making a call
To make a call, follow the procedure below:
1. Press the button on the
steering
wheel. The “Phone” screen will appear on
the display.
2. Select one of the following options to make a
cal ...
Luggage cover (CrossCabriolet models)
A luggage cover is used to separate the trunk
and the top storage area.
To use the luggage cover, pull it out and hang
both sides on the hooks1 .
To stow the luggage cover, remove it from th ...