How to use the NISSAN controller
Use the NISSAN controller to choose an item on the display screen. Highlight an item on the display using the main directional buttons 2 (certain Navigation System functions use the additional directional buttons 6 ) or the center dial 3 . Then press the ENTER button 1 to select the item or perform the action.
The BACK button 4 has two functions:
● Go back to the previous display (cancel).
If you press the BACK button 4 during setup, the setup will be canceled and/or the display will return to the previous screen.
● Finish setup.
In some screens, pressing the BACK button 4 accepts the changes made during setup.
For the VOICE button 5 functions, refer to the separate Navigation System Owner’s Manual.
See also:
Emergency engine shut off
To shut off the engine in an emergency situation
while driving, perform the following procedure:
• Rapidly push the push-button ignition
switch
3 consecutive times in less than 1.5
seconds, or ...
Call volume
Adjusting the incoming or outgoing call volume
may improve clarity if reception between callers is
unclear.
● Incoming call—adjusting this setting allows
you to hear a difference in volu ...
Forward-facing child restraint installation using LATCH
Refer to all Warnings and Cautions in the “Child
Safety” and “Child Restraints” sections before
installing a child restraint.
Follow these steps to install a forward-facing
child restrai ...