Luggage cover (CrossCabriolet models)
A luggage cover is used to separate the trunk and the top storage area.
To use the luggage cover, pull it out and hang both sides on the hooks1 .
To stow the luggage cover, remove it from the hooks and hold it until it is retracted.
The luggage cover must be pulled out and hung on hooks 1 for the soft top to oparate. (See “Soft top (CrossCabriolet models)” in the “3.
Pre-driving checks and adjustments” section.)
WARNING
• Do not
place anything over the
luggage cover during soft top operation.
• Do not
place or leave objects under
the cover that may push the cover
up.
• Do not
place items on sides that
intrude into luggage cover area.
See also:
Rear and rear-wide view monitor with Moving Object Detection (MOD) (if so
equipped)
When the shift lever is shifted into the R
(Reverse) position, the monitor display shows
view to the rear of the vehicle.
The system is designed as an aid to the driver in
detecting large statio ...
Emergency engine shut off
To shut off the engine in an emergency situation
while driving, perform the following procedure:
– Rapidly push the push-button ignition switch 3
consecutive times in less than 1.5 seconds, or
...
Environmental factors influence the rate of corrosion
Moisture
Accumulation of sand, dirt and water on the vehicle
body underside can accelerate corrosion.
Wet floor coverings will not dry completely inside
the vehicle and should be removed for dry ...