Operating the HomeLink® Universal Transceiver
The HomeLink® Universal Transceiver, after it is programmed, can be used to activate the programmed device. To operate, simply press and release the appropriate programmed HomeLink® Universal Transceiver button. The amber indicator light will illuminate while the signal is being transmitted.
For convenience, the hand-held transmitter of the device may also be used at any time.
See also:
Brake fluid
For additional brake fluid information, see “Capacities and recommended fuel/lubricants”
in the “9. Technical and consumer information” section of this manual.
- Use only new fluid from a ...
Reporting safety defects
For USA
If you believe that your vehicle has a defect
which could cause a crash or could
cause injury or death, you should immediately
inform the National Highway Traffic
Safety Administration (N ...
Giving voice commands
1. Press the switch located on
the steering
wheel.
2. A list of commands appears on the screen,
and the system announces, “Would you like
to access Phone, Navigation, Information,
Audio ...