Mirrors
Inside mirror
Inside mirror
Adjust the height and the angle of the inside mirror to the desired position.
Manual anti-glare type
The night position 1 will reduce glare from the headlights of vehicles behind you at night.
Use the day position 2 when driving in daylight hours.
Use the night position only when necessary, because it reduces rear view clarity.
Automatic anti-glare type
The inside mirror is designed so that it automatically changes reflection according to the intensity of the headlights of the following vehicle.
The anti-glare system will be automatically turned on when the ignition switch is turned to the ON position.
Type A:
When the system is turned on, the indicator light A will illuminate and excessive glare from the headlights of the vehicle behind you will be reduced.
Push the switch B to make the inside rearview mirror operate normally and the indicator light will turn off. Push the switch again to turn the system on.
Do not allow any object to cover the sensors C or apply glass cleaner on them. Doing so will reduce the sensitivity of the sensors, resulting in improper operation.
For the compass operation, see “Compass” in the “2. Instruments and controls” section.
For the HomeLink® Universal Transceiver operation, see “HomeLink® Universal Transceiver” in the “2. Instruments and controls” section.
Type B:
When the system is turned on, the indicator light A will illuminate and excessive glare from the headlights of the vehicle behind you will be reduced.
Push the switch B for 3 seconds to make the inside mirror operate normally and the indicator light will turn off. Push the switch again for 3 seconds to turn the system on.
Do not hang any objects on the mirror or apply glass cleaner. Doing so will reduce the sensitivity of the sensor C , resulting in improper operation.
Outside mirrors
Outside mirrors
Objects viewed in the outside mirror on the passenger side are closer than they appear. Be careful when moving to the right. Using only this mirror could cause an accident. Use the inside mirror or glance over your shoulder to properly judge distances to other objects.
Adjusting outside mirrors
The outside mirror control switch is located on the left side of the instrument panel.
The outside mirror will operate only when the ignition switch is in the ACC or ON position.
Turn the switch right or left to select the right or left side mirror, then adjust using the control switch.
Defrosting outside mirrors (if so equipped)
The outside mirrors will be heated when the rear window defroster switch is operated.
Foldable outside mirrors
Fold the outside mirror by pushing it toward the rear of the vehicle.
Vanity mirror
Vanity mirror
To use the front vanity mirror, pull down the sun visor and pull up the cover.
See also:
Regulatory Information
FCC Regulatory information
– CAUTION: To maintain compliance with
FCC’s RF exposure guidelines, use only the
supplied antenna. Unauthorized antenna,
modification, or attachments could damage
...
Power outlet
Instrument panel
Center console (if so equipped)
The power outlet is located in the instrument panel and the center console (if
so equipped).
- The outlet and plug may be hot during or imme ...
Operating tips
The sunload sensor A on the instrument panel
helps maintain a constant temperature. Do not
put anything on or around this sensor. ...