Programming HomeLink® for Canadian customers
Prior to 1992, D.O.C. regulations required handheld transmitters to stop transmitting after 2 seconds.
To program your hand-held transmitter to HomeLink®, continue to press and hold the HomeLink® button (see steps 2 - 4 under “Programming HomeLink®”) while you press and repress (“cycle”) your hand-held transmitters every 2 seconds until the indicator light flashes rapidly (indicating successful programming).
NOTE:
When programming a garage door opener, etc., it is advised to unplug the device during the “cycling” process to prevent possible damage to the garage door opener components.
See also:
Car phone and CB radio
When installing a car phone or a CB radio in your vehicle, be sure to observe
the following cautions, otherwise the new equipment may adversely affect the electronic
control modules and electronic ...
Seat belt warning light and chime
The seat belt warning light and chime are designed to remind the driver, front passenger, and rear passengers to
fasten their seat belts before and during travel. In the Nissan Murano, th ...
Air cleaner
Pull the tabs1 and pull out the cover2 .
The air cleaner filter should not be cleaned and
reused. Replace it according to the maintenance
log shown in the “NISSAN Service and Maintenance
Gui ...