Operating the HomeLink® universal transceiver

The HomeLink® Universal Transceiver, after it is programmed, can be used to activate the programmed device. To operate, simply press and release the appropriate programmed HomeLink® Universal Transceiver button. The amber indicator light will illuminate while the signal is being transmitted.

For convenience, the hand-held transmitter of the device may also be used at any time.

    See also:

    Magnetic Wireless charger
    Basic Information Indicator Charging pad The magnetic wireless charger in the Nissan Murano is located at the front of the center console, below the climate control system. To begi ...

    Audio system
    Audio operation precautions Radio Place the ignition switch to the ACC or ON position and push the radio band select button to turn on the radio. If you listen to the radio with the engine not run ...

    Readiness for Inspection/Maintenance (I/M) test
    A vehicle equipped with All-Wheel Drive (AWD) should never be tested using a two wheel dynamometer (such as the dynamometers used by some states for emissions testing), or similar equipment. Make ...