Fuel-filler cap
WARNING
● Gasoline is extremely flammable and highly explosive under certain conditions.
You could be burned or seriously injured if it is misused or mishandled.
Always stop the engine and do not
smoke or allow open flames or sparks
near the vehicle when refueling.
● Do not attempt to top off the fuel tank
after the fuel pump nozzle shuts off
automatically. Continued refueling may
cause fuel overflow, resulting in fuel
spray and possibly a fire.
● Use only an original equipment type
fuel-filler cap as a replacement. It has a
built-in safety valve needed for proper
operation of the fuel system and emission
control system. An incorrect cap
can result in a serious malfunction and
possible injury. It could also cause
the
Malfunction Indicator Light
(MIL) to come on.
● Never pour fuel into the throttle body to
attempt to start your vehicle.
● Do not fill a portable fuel container in
the vehicle or trailer. Static electricity
can cause an explosion of flammable
liquid, vapor or gas in any vehicle or
trailer. To reduce the risk of serious
injury or death when filling portable fuel
containers:
– Always place the container on the
ground when filling.
– Do not use electronic devices when
filling.
– Keep the pump nozzle in contact
with the container while you are filling
it.
– Use only approved portable fuel containers
for flammable liquid.
CAUTION
● Do not use E-15 or E-85 fuel in your
vehicle. For further information see the
“Fuel Recommendation”in the “Technical
and consumer information” section
of this manual.
● The LOOSE FUEL CAP warning will appear
if the fuel-filler cap is not properly
tightened. It may take a few driving trips
for the message to be displayed. Failure
to tighten the fuel-filler cap properly
after the LOOSE FUEL CAP warning appears
may cause the
Malfunction
Indicator Light (MIL) to illuminate.
● Failure to tighten the fuel-filler cap
properly may cause the
Malfunction
Indicator Light (MIL) to illuminate.
If the
light illuminates because
the fuel-filler cap is loose or missing,
tighten or install the cap and continue
to drive the vehicle. The
light
should turn off after a few driving trips.
If the
light does not turn off
after a
few driving trips, have the vehicle inspected
by a NISSAN dealer.
● For additional information, see the
“Malfunction Indicator Light (MIL)” in
the “Instruments and Controls” section
in this manual.
● If fuel is spilled on the vehicle body,
flush it away with water to avoid paint
damage.

To remove the fuel-filler cap:
1. Turn the fuel-filler cap counterclockwise to
remove.
2. Put the fuel-filler cap on the cap holder 1
while refueling.
To install the fuel-filler cap:
1. Insert the fuel-filler cap straight into the fuelfiller
tube.
2. Turn the fuel-filler cap clockwise until a
single click is heard.

Loose Fuel Cap warning
The LOOSE FUEL CAP warning appears in the vehicle information display when the fuel-filler cap is not tightened correctly after the vehicle has been refueled. It may take a few driving trips for the message to be displayed. To turn off the warning, perform the following:
1. Remove and install the fuel-filler cap as soon
as possible. See “Fuel-filler cap”.
2. Tighten the fuel-filler cap until it clicks.
3. Press the
next button A on the
steering
wheel for about 1 second to turn off the
LOOSE FUEL CAP warning B after tightening
the fuel-filler cap.
See also:
Rear window wiper and washer switch (Hardtop
models)
WARNING
In freezing temperatures the washer
solution may freeze on the rear window
glass and obscure your vision. Warm
the rear window with the defroster
before you wash the rear window.
CAUTION ...
Keys
Type A
Type B
Type C
1. Intelligent Key (2 sets)
2. Mechanical key
3. Key number plate (1 plate) ...
Maintenance requirement
Some day-to-day and regular maintenance is
essential to maintain your vehicle’s fine mechanical
condition, as well as its emission and engine
performance.
It is the owner’s responsibility to ...
