Entry/exit function

This system is designed so that the driver’s seat and automatic operation steering column will automatically move when the shift selector is in the P (Park) position. This allows the driver to get into and out of the driver’s seat more easily.

The driver’s seat will slide backward and the steering column will move up:

● When the driver’s door is opened with the ignition switch placed in the LOCK position.
● When the ignition switch is turned from ACC to LOCK with the driver’s door open.

The driver’s seat and steering wheel will return to the previous position:

● When the driver’s door is closed with the ignition switch placed in the LOCK position.
● When the ignition switch is turned from ACC toONwhile the shift selector is in the P (Park) position.

The entry/exit function can be adjusted or canceled through the Vehicle Settings in the vehicle information display by performing the following:

● Switch the Exit Seat Slide from ON to OFF.
● Switch the Exit Steering UP from ON to OFF.

Restarting the entry/exit function

If the battery cable is disconnected or if the fuse opens, the entry/exit function will be disabled. Drive the vehicle over 25 MPH (40 km/h) to restart the entry/exit function. You can also restart the entry/exit function using the following procedure.

1. Connect the battery cable or replace the fuse.
2. Open and close the driver’s door more than 2 times with the ignition switch in the LOCK position.

The entry/exit function should now work properly.

    See also:

    Moonroof (if so equipped for Hardtop models)
    WARNING • In an accident you could be thrown from the vehicle through an open moonroof. Always use seat belts and child restraints. • Do not allow anyone to stand up or extend any portio ...

    Programming HomeLink® for Canadian customers
    Prior to 1992, D.O.C. regulations required handheld transmitters to stop transmitting after 2 seconds. To program your hand-held transmitter to HomeLink®, continue to press and hold the HomeLin ...

    Starting the engine
    1. Apply the parking brake. 2. Move the shift selector to P (Park) or N (Neutral). P (Park) is recommended. The starter is designed not to operate if the shift selector is in any of the driving p ...