RearView Monitor (if so equipped)

When the shift selector is shifted into the R (Reverse) position, the monitor display shows a rearward view from the vehicle.

The system is designed as an aid to the driver in situations such as slot parking or parallel parking.

WARNING

● The RearView Monitor is a convenience but it is not a substitute to check behind the vehicle when backing up.
● The driver is always responsible for safety during parking and other maneuvers.
● Objects viewed in the RearView Monitor differ from actual distance because a wide-angle lens is used.
● Objects in the rearview will appear visually opposite than when viewed in the rearview and outside mirrors.
● Make sure that the liftgate is securely closed when backing up.
● Underneath the bumper and the corner areas of the bumper cannot be viewed on the RearView Monitor because of its monitoring range limitation.
● Do not put anything on the rear view camera. The rear view camera is installed above the license plate.
● When washing the vehicle with highpressure water, be sure not to spray it around the camera. Otherwise, water may enter the camera unit causing water condensation on the lens, a malfunction, fire or an electric shock.
● Do not strike the camera. It is a precision instrument. Otherwise, it may malfunction or cause damage resulting in a fire or an electric shock.

CAUTION

Do not scratch the camera lens when cleaning dirt or snow from the lens.

See also:

Reporting safety defects
For USA If you believe that your vehicle has a defect which could cause a crash or could cause injury or death, you should immediately inform the National Highway Traffic Safety Administration (N ...

Jump starting
To start your engine with a booster battery, the instructions and precautions below must be followed. WARNING • If done incorrectly, jump starting can lead to a battery explosion, resulting in ...

Forward-facing child restraint installation using the seat belts
WARNING The three-point seat belt with Automatic Locking Retractor (ALR) must be used when installing a child restraint. Failure to use the ALR mode will result in the child restraint not being p ...