Operating tips
● When the engine coolant temperature and outside air temperature are low, the air flow from the foot outlets may not operate for a maximum of 150 seconds. However, this is not a malfunction. After the coolant temperature warms up, air flow from the foot outlets will operate normally.
The sunload sensor, located on the top driver’s side of the instrument panel, helps the system maintain a constant temperature. Do not put anything on or around this sensor.
See also:
ProPILOT Assist mode indicators
Basic information
ProPILOT Assist can operate in several modes according to the current road, vehicle, system, and
driver-monitoring conditions. Each mode is identified by a specific indicator co ...
Readiness for inspection/maintenance (I/M) test
WARNING
A vehicle equipped with Four-Wheel Drive
(4WD) should never be tested using a two
wheel dynamometer (such as the dynamometers
used by some states for emissions
testing), or similar equipm ...
If your vehicle is stolen
If your vehicle is stolen, you should change the
codes of any non-rolling code device that has
been programmed into HomeLink®. Consult the
Owner’s Manual of each device or call the
manufacturer ...