Programming trouble-diagnosis
If the HomeLink® does not quickly learn the hand-held transmitter information:
● replace the hand-held transmitter batteries
with new batteries.
● position the hand-held transmitter with its
battery area facing away from the
HomeLink® surface.
● press and hold both the HomeLink® and
hand-held transmitter buttons without interruption.
● position the hand-held transmitter 1 -
3 inches (26 - 76 mm) away from the
HomeLink® surface. Hold the transmitter in
that position for up to 15 seconds. If
HomeLink® is not programmed within that
time, try holding the transmitter in another
position – keeping the indicator light in view
at all times.
If you have any questions or are having difficulty programming your HomeLink® buttons, refer to the HomeLink® web site at: www.homelink.com or call 1-800-355-3515.
See also:
Rear-facing child restraint installation using the seat belts
WARNING
The three-point seat belt with Automatic
Locking Retractor (ALR) must be used
when installing a child restraint. Failure to
use the ALR mode will result in the child
restraint not being p ...
Opening the top using the Intelligent Key
The soft top can be opened using the door
handle request switch.
Opening the soft top
Push the ignition switch to the OFF position and
make sure to carry the Intelligent Key with you.
Make su ...
OFF button
To change the display brightness, press
the OFF button. Pressing the button
again
will change the display to the day
or the
night display. The brightness can
then be
adjusted using the NI ...