Automatic door locks

● All doors lock automatically when the vehicle speed reaches 15 MPH (24 km/h).
● All doors unlock automatically when the ignition is placed in the OFF position.

The automatic unlock function can be deactivated or activated. To deactivate or activate the automatic door unlock system, perform the following procedure:

1. Close all doors.
2. Place the ignition switch in the ON position.
3. Within 20 seconds of performing Step 2, push and hold the power door lock switch to the 5 seconds. position (UNLOCK) for more than 5 seconds.
4. When activated, the hazard indicator will flash twice. When deactivated, the hazard indicator will flash once.
5. The ignition switch must be placed in the OFF and ON position again between each setting change.

When the automatic door unlock system is deactivated, the doors do not unlock when the ignition switch is placed in the OFF position. To unlock the door manually, use the inside lock knob or the power door lock switch (driver’s or front passenger’s side).

NOTE:

The automatic door unlock function can be changed using the Vehicle Settings in the vehicle information display. The “Auto Door Unlock” choices are:

● Off
● IGN OFF
● Shift into P

    See also:

    Programming troubleshooting
    If the HomeLink® does not quickly learn the hand-held transmitter information: • replace the hand-held transmitter batteries with new batteries. • position the hand-held transmitter with ...

    Operating the manual liftgate (if so equipped)
    Liftgate switch Instrument panel switch The power door lock system allows you to lock or unlock all doors including the liftgate simultaneously. To open the liftgate, pull up on the handle ...

    Programming HomeLink® for Canadian customers and gate openers
    Canadian radio-frequency laws require transmitter signals to “time-out” (or quit) after several seconds of transmission – which may not be long enough for HomeLink® to pick up the signal du ...