Seat belts
The seat belts can be cleaned by wiping them with a sponge dampened in a mild soap solution.
Allow the belts to dry completely in the shade before using them. See “Seat belt maintenance” in the “Safety – Seats, seat belts and supplemental restraint system” section of this manual.
WARNING
Do not allow wet seat belts to roll up in the retractor. NEVER use bleach, dye or chemical solvents to clean the seat belts, since these materials may severely weaken the seat belt webbing.
See also:
Hazard warning flasher switch
Push the switch on to warn other drivers when
you must stop or park under emergency conditions.
All turn signal lights flash.
WARNING
● If stopping for an emergency, be sure to
move the ...
Control buttons
1. PHONE SEND button
Push the button to initiate a VR session or
answer an incoming call. You can also use
the button to skip through system feedback
and to enter commands during a call.
2. PH ...
Operating the manual liftgate (if so equipped)
Liftgate switch
Instrument panel switch
The power door lock system allows you to lock or
unlock all doors including the liftgate simultaneously.
To open the liftgate, pull up on the handle ...