Installing top tether strap (Hardtop models)
First, secure the child restraint with the LATCH lower anchors (rear outboard seat positions only) or the seat belt, as applicable.
1. If necessary, raise or remove the head restraint or headrest to position the top tether strap over the top of the seatback. If the head restraint or headrest is removed, store it in a secure place. Be sure to reinstall the head restraint or headrest when the child restraint is removed.
See “Head restraints” earlier in this section for head restraint or headrest adjustment, removal and installation information.
Position the top tether strap over the top of the seatback.
2. Secure the top tether strap to the tether
anchor point on the back of the seatback
behind the child restraint.
3. Refer to the appropriate child restraint
installation procedure steps in this section
before tightening the tether strap.
If you have any questions when installing a top tether strap, consult your NISSAN dealer for details.
See also:
Tire and loading information label
The cold tire pressure is shown on the Tire and
Loading Information label. The label is located as
shown. ...
Readiness for Inspection/Maintenance (I/M) test
WARNING
A vehicle equipped with All-Wheel Drive
(AWD) should never be tested using a
two wheel dynamometer (such as the
dynamometers used by some states for
emissions testing), or similar equipme ...
Continuously Variable Transmission (CVT) fluid
CAUTION
• Use only Genuine NISSAN CVT Fluid
NS-3. Do not mix with other fluids.
• Using transmission fluid other than
Genuine NISSAN CVT Fluid NS-3
will damage the CVT, which is not
covered ...