How to use multi-function controller
Choose an item on the display using the main directional buttons2 (or additional directional buttons 6 with navigation system) or center dial 3 , and push the ENTER button 1 for operation.
If you push the BACK button 4 before the setup is completed, the setup will be canceled and/or the display will return to the previous screen. This button can also be used to delete characters that have been input.
After the setup is completed, push the BACK button4 and return to the previous screen.
For the VOICE button5 functions, refer to the separate Navigation System Owner’s Manual.
See also:
LATCH Lower Anchors System
LATCH label location (Hardtop models)
LATCH label location (CrossCabriolet models)
Your vehicle is equipped with special anchor
points that are used with the LATCH (Lower
Anchors and Tethers f ...
Car phone or CB radio
When installing a car phone or a CB radio in
your vehicle, be sure to observe the following
cautions, otherwise the new equipment may
adversely affect the electronic control modules
and electronic ...
Locking with inside lock knob
To lock the door individually, move the inside
lock knob to the lock position1 then close the
door.
To unlock, move the inside lock knob to the
unlock position2 .
When locking the door withou ...