Checking bulbs

With all doors closed, apply the parking brake and place the ignition switch to the ON position without starting the engine. The following lights will come on:

The following lights come on briefly and then go

The following lights come on briefly and then go off:

If any light fails to come on, it may indicate

If any light fails to come on, it may indicate a burned-out bulb or an open circuit in the electrical system. Have the system repaired promptly.

    See also:

    Troubleshooting guide
    The system should respond correctly to all voice commands without difficulty. If problems are encountered, try the following solutions. Where the solutions are listed by number, try each solutio ...

    F.M.V.S.S./C.M.V.S.S. certification label
    The Federal/Canadian Motor Vehicle Safety Standard (F.M.V.S.S./C.M.V.S.S.) certification label is affixed as shown. This label contains valuable vehicle information, such as: Gross Vehicle Weigh ...

    Drive belts
    1. Alternator 2. Water pump 3. Drive belt auto-tensioner 4. Crankshaft pulley 5. Air conditioner compressor Be sure the ignition switch is in the OFF or LOCK position before servicing drive ...