How to use the NISSAN controller
Use the NISSAN controller to choose an item on the display screen. Highlight an item on the display using the main directional buttons 2 (certain Navigation System functions use the additional directional buttons 6 ) or the center dial 3 . Then press the ENTER button 1 to select the item or perform the action.
The BACK button 4 has two functions:
● Go back to the previous display (cancel).
If you press the BACK button 4 during setup, the setup will be canceled and/or the display will return to the previous screen.
● Finish setup.
In some screens, pressing the BACK button 4 accepts the changes made during setup.
For the VOICE button 5 functions, refer to the separate Navigation System Owner’s Manual.
See also:
Wiper and washer switch
Switch operation
Type A (if so
equipped)
Type B (if so equipped)
WARNING
In freezing temperatures the washer solution may freeze on the windshield and obscure your vision, which may
...
Environmental factors influence the rate of corrosion
Moisture
Accumulation of sand, dirt and water on the
vehicle body underside can accelerate corrosion.
Wet floor coverings will not dry completely
inside the vehicle, and should be removed for
d ...
Engine cooling system
The engine cooling system is filled at the factory with a pre-diluted mixture
of 50% Genuine NISSAN Long Life Antifreeze/Coolant (blue) and 50% water to provide
year-round anti-freeze and coolant ...